How to upload and run the program in a prototype module to combine esp32, lora ra-2, oled and gps neo6

1

how to upload and run the program in a prototype module to combine esp32, lora ra-2, oled and gps neo6, can you please tell me? I have flashed the file.bin using flash_download_tools_v _3.8.5 to esp32, because I can’t install ESPHoom-Flasher, after flashing the file.bin I haven’t seen an active bluetooth network, I’ve tried several ways but there’s also no result, whether required additional programs that need to be uploaded in esp32? thanks

2

Welcome to the Meshtastic community! You may be able to use the TBeam v0.7 firmware.bin and copy the pinouts or look at building the firmware yourself using this guide https://github.com/meshtastic/Meshtastic-device/blob/master/docs/software/build-instructions.md

3

Hi. I also use the same setup(custom board). I take pin’s from https://github.com/meshtastic/Meshtastic-device/wiki/Hardware-Information - TTGO Lora32 V2.0.
https://github.com/meshtastic/Meshtastic-device/releases -firmware-tlora-v2-EU433-1.1.5.bin (any version You can use).
GPS_RX_PIN 36
GPS_TX_PIN 13