Hi All,
The 3d printer finally arrived this morning after some logistical troubles apparently.
I have put the unit together and paid specific attention to adjusting the rollers and leveling the heated bed, well then we went on a nice ride on the E-bikes as it was really nice weather overhere (17 degrees celcius) , back home started to find a drawing of my liking’s and loaded it into Ultimaker Cura, sliced the drawing and saved on an SD card that goes into the printer and off I went my 1st 3D print, after staring at the printer obeserving the process for well over a hour I produced my first housing/case for the LilyGO TTGO T3 LoRa32 868MHz V2.1.6 ESP32, I was really chuffed with the result and I am really happy with my choice of buy and the good advice from all you guys, thank again guys! the result is posted in 3D Printed Cases etc - #95 by mark