I am using the EE433-modules. Easily configuring via the RX/TX port and M0/M1/AUX. On the T-board I have those not connected. So besides the SPI-programming I would like to use also the RX/TX/M0/M1/AUX (in combination with the E32-library. Are this the IO0-IO4 pins in the schematic and will it working right away or is there a need for new software in the module. Since I had a dead GPS module (1PPS is good working) I want to use those RX/TX lines.
Hi!
Our firmware currently requires the modules that uses SPI but would gladly accept a PR to enable the functionality.
Since you’re making a custom board, any pin assignments are up to you.
Thanks!