Location Precision appears to be messing up fixed location

Support
1

I have been trying to figure this out for the past few days, I don’t know what happened or why but on my nodes webui map it shows it in the correct exact coordinates I set it to on python. When I look on meshmap its showing a location precision circle and its way off from where I put it. I have tried resetting the channel settings, setting precision to max on python, erasing the flash and restarting, updating and downgrading the firmware. Nothing works at all. Thanks in advance for your help.

EDIT: I wanted to also add that after I reflashed the firmware and put my settings back, the position was correct for about 5 minutes before reverting back to the incorrect spot. I also do not have provide phone location to mesh enabled or anything like that.

2

image
image1172×1030 121 KB

I am talking about the blue pin on the right, it should be next to the blue pin on the left but it’s not

3

image
image2035×1193 152 KB

This is what it should look like

4

image
image2212×1711 147 KB

5

image
image2066×1023 102 KB

6

image
image2105×1697 147 KB

7

image
image2093×1741 172 KB

(Just supplying screenshots of relevant settings)

8

Precision is a per channel setting, your fixed position is set and then the reduced precision location is broadcast based on the channel settings.

9

That’s what I thought as well but my channel settings would imply to me that it shouldn’t do that. I added a screenshot of it above.

11

Just watching Meshmap and it bounced back to the right spot for a couple minutes but it just moved back to the incorrect spot