864,0 - 865,0 MHz ERP 25mW, Duty Cycle 0.1% (3.6 sec in hour) or LBT (Listen Before Talk), prohibited in airports.
866,0 - 868,0 MHz ERP 25mW, Duty Cycle 1% or LBT, PSD (Power Spectrum Density) 1000mW/MHz, prohibited in airports
868,7 - 869,2 MHz ERP 100mW, Duty Cycle 10% or LBT, no resctrictions
and according to RP2-1.0.2 LoRaWAN® Regional Parameters RP2-1.0.2 LoRaWAN® Regional Parameters - LoRa Alliance®
I propose to use following meshtastic bandplan:
1 channel - central frequency 868.9MHz 125kHz band
Protective band - 75kHz
2 channel - central frequency 869.1MHz 125kHz band
the RU Region with central frequency 868.9 mhz should have a name “RU869”.
This is important for two reasons
A) Users will set up this region only on 868 boards
B) Sooner or later there will be requests to add a second (433Mhz) frequency to app menu, (as this frequency is also legal in Russia), and it will be sensible to have RU869 and RU433
By the way - any reasonable suggestions for central frequency in 433 range ?
РУ :
Есть официальный документ от лора-альянс, где прописаны используемый в России частоты.
Предлагаю в настройки на телефоне, помимо региона прописать возможность вводить частоту в диапазоне. А так же предусмотреть вариант ввода частот в расширенном диапазоне, позволяемых оборудованием. Сделать это для тестирования. Расположить где-нибудь в специальном скрытом инженерном меню.
ENG:
There is a document from Laura-Alliance, where the official frequencies used in Russia are spelled out.
I suggest in the phone, in addition to the region, register the possibility of entering the frequency in the range. And also provide for the option of entering frequencies in an extended range, allowing the equipment. Do it for testing. Place it somewhere in a special hidden engineering menu.
РУ:
По поводу стартовой частоты на 433МГц вопрос очень сложный, т.к. в больших городах и пригородах этот диапазон очень сильно забит помехами. Есть идеи в качестве эксперимента использовать участок 446.1…446.2, т.к. он ещё относительно чистый. Вопрос законности - спорный и требует уточнения у местных властей. (ИМХО, в качестве экспериментов этот диапазон можно использовать и особо никто не будет ругаться)
Именно для этого предлагаю сделать скрытое инженерное меню что бы можно было экспериментировать.
ENG:
As for the starting frequency at 433 MHz, the question is very difficult. in large cities and suburbs, this range is very much jammed with interference. There are ideas to use the section 446.1 … 446.2 (446.150 in the center) as an experiment, because it is still relatively clean. The issue of legality is controversial and requires clarification from local authorities. (IMHO, this range can be used as experiments and no one will swear especially)
It is for this that I propose to make a hidden engineering menu so that you can experiment.
Предлагаю частоты по умолчанию в 2х вариантах: 433.200 и 446.150
I offer default frequencies in 2 versions: RU1: 433.200 and RU2: 446.150
В широкой моде 250кГц как раз укладываемся на начало участка 433.075МГц. На 446.150 работа в узкополосном режиме, что бы не мешать 5…8 каналу PMR участка.
According attached documents 446-446.1MHz unlicensed is for PMR446 only.
as for 433 band its same as EU433 with small difference - allowed power in Russia - EIRP= -17dBWt = 13dBm =10dBm power + 3 dBi antenna Whats pretty same as EU 10mW
Supporting initial proposal to rename RU to RU868 to avoid misunderstandings.